Fixed Electrical Plug In Chandelier

Published On May 23, 2018 | By Kandra | Lighting Design

Plug In Chandelier – How to install a suspension or chandelier? This electrical installation is accessible to people with a minimum of manual practice. The luminaire will be maintained using a hook itself fixed inside a DCL (Fixture Connection Arrangement) box embedded in the masonry. Before any intervention at the DCL box, locate the electrical panel, then cut off the power supply to the circuit breaker or fuse holder supplying the circuit of the luminaire to be installed to avoid a domestic accident.

Plug In Chandelier Pendant

Plug In Chandelier Pendant

In order to be sure of the absence of electricity, simply observe if the plug in chandelier that is present with the base on the DCL box is off. Remove the lamp from the base, then press on the side tab and remove the assembly. You see on the side of the base a small pin, to eclipse there. Take the pin and unscrew the screw depending on the models of the cover to access the electrical part.

18 Photos Gallery of: Fixed Electrical Plug In Chandelier

Image of: Classy Plug In Chandelier

Image of: Amazing Plug In Chandelier

Image of: New Plug In Chandelier

Image of: Last Plug In Chandelier

Image of: Nice Plug In Chandelier

Image of: New Plug In Chandelier Design

Image of: Plug In Chandelier Modern

Image of: Plug In Chandelier Kits

Image of: Plug In Chandelier Ikea

Image of: Plug In Chandelier Hanging

Image of: Plug In Chandelier Glamorous

Image of: Plug In Chandelier Elegant

Image of: Plug In Chandelier Design

Image of: Plug In Chandelier Decoration

Image of: Plug In Chandelier Custom

Image of: Plug In Chandelier Contemporary

Image of: Plug In Chandelier Awesome

Image of: Plug In Chandelier Pendant

Related  Chandelier Shades and Tips to Choose Chandelier Lamp Shades

Strip the electrical cable from the suspension plug in chandelier to a maximum of 2 cm of wire, as the cable must enter the inside of the plastic part of the pin so that it does not have direct access to the wires. The next step is to close the spindle cover and tighten the screw making sure that the cable fits inside the spindle. Insert the pin inside its slot inside the DCL box until you hear a “clip”.

Comments are closed.